Probe Master 4241A
с пропускной способностью до 70 МГц
Стоимость указана в Рублях DDP Москва по безналичному расчету включая НДС 20%
Дифференциальный датчик для измерения мощности высокого напряжения - Probe Master 4241A
4241A соответствует требованиям IEC61010-031 категории I и идеально подходит для измерения высокоскоростных скачков напряжения в цепях силовой электроники.
Особенности:
- Дифференциал до + 7000 В (постоянный ток + пиковый переменный ток)
- Полоса пропускания до 70 МГц
- Сертификат безопасности
- Индикатор превышения диапазона
Номер в Госреестре | Наименование СИ | Обозначение типа СИ | Изготовитель | Срок свидетельства или заводской номер |
---|---|---|---|---|
56823-14 | Пробники высоковольтные дифференциальные | 4241А | Фирма "Probe Master Inc.", США | 14.03.2019 |
Bandwidth | DC to 70MHz (-3dB) |
Attenuation | 1:100/1000 |
Accuracy | + 2% |
Input Impedance | 50 M OHm/10pF each side to ground |
Input Voltage -Category |
CAT I |
-Differential Range* |
500Vrms and +700V (DC+Peak AC) @ 1/100 5000Vrms and +7000V (DC+Peak AC) @1/1000 |
-Common Mode Range* | 5000Vrms and+7000V (DC+Peak AC) @ 1/100 & 1/1000 |
-Absolute Max. Voltage* (Differential or Common Mode) |
5000Vrms and+7000V (DC+Peak AC) @ 1/100 & 1/1000 |
Output Voltage -Swing (into 50kohm load) -Offset (typical) -Noise (typical) -Source Impedance (typical) |
+ 7V <+5mV 0.9m Vrms 50 Ohm ( for using 1Mohm input system oscilloscope) |
CMRR (typical) | -80dB @ 50Hz, -60dB @ 20Hz |
Ambient Operating Temperature | -10 to 40 degree centigrade |
Ambient Storage Temperature | -30 to 70 degree centigrade |
Ambient Operating Humidity | Up to 85% RH |
Ambient Storage Humidity | Up to 85% RH |
Power Requirements** | Standard 4 x AA cells or 9VDC adapter (Both Included) Options Power Leads |
Length of BNC Cable | 26" |
Length of Input Leads | 23" |
Weight | 0.9 lb |
Dimensions | (LxWxH) 8" x 3 1/4" x 1 1/2" |
*Voltage limit is the lesser of the DC+Peak AC and RMS values.
**a. The supplied voltage must be less than 12V and greater than 4.4V, otherwise the probe could be damaged or will not operate properly.
b. polarity is "+" inside and "¡V" outside. For wrong polarity, built-in circuit protects the probe, no danger or damage will occur.
c. When the voltage of the cells become too low, the power indicator on the panel will flicker.
d. The adjustment screw on the front panel of the unit is the output offset adjustment. The output offset adjustment is to adjust the output voltage to zero before measuring.
Подробные технические характеристики, информация производителя, брошюры:
-
Каталоги производителя: